All of the products sold on fomofoam.com are intended for PROFESSIONAL USE ONLY.
Do you work smart? Do your employees and customers?
Working smart is about choosing the best solution for energy efficiency challenges and then executing the project safely.
All of Fomo Foam Insulation’s™ products are low pressure products meaning that the dispensed pressure is below 250 psi. High pressure foams are dispensed at 1,000 psi and above. However, like high pressure foams, Fomo Foam Insulation’s™ products contain diisocyanates. This chemical may cause sensitization by inhalation and/or direct skin contact and can be an irritant to the eyes, nose and throat. Sensitization may become apparent through coughing, pulmonary secretions, chest pain, breathing difficulty and/or asthma.
All of Fomo Foam Insulation’s™ polyurethane foams MUST always be used in conjunction with a certified respiratory program in addition to safety glasses or goggles, nitrile gloves and clothing that protects from skin exposure.
Required respirators must be NIOSH approved and a medical evaluation, fit testing and training should be provided before use. Fomo Foam Insulation™ recommends utilizing one of the following with our low pressure, two component foams:
NIOSH approved negative pressure half mask respirator with organic vapor cartridges and particulate pre-filters
NIOSH approved PAPR (powered air purifying respirator) with an organic vapor cartridge
MSDS, TDS and Operating Instructions are included with all of our products, please read all materials thoroughly before use.
For additional information on health and safety issues related to spray foam, visit www.spraypolyurethane.org.
Safe Handling and Use:
Fomo Foam Insulation™ products are for professional use only.
Children should never use these products.
Use the Fomo Foam Insulation™ products in well ventilated areas. If the job site is not ventilated, Fomo Foam Insulation™ recommends adding mechanical ventilation, or wearing a powered air purifying respirator (PAPR).
Storage and Disposal:
Store out of reach of children.
Before the first use of the product, store in a room temperature, dry area.
Do not expose the kit, cans or tanks to open flames or temperatures above 120 degrees F (49C). Warm the kits and cans for a minimum of 1 day at room temperature. During colder months it may take 2-3 days to warm up the chemicals to optimum temperature. Always agitate the cylinders well prior to use in order to thoroughly mix the chemicals and assure even chemical temperature.
After initial use of spray foam kits, close the valves and store at room temperature. Do not drain or remove hoses as they should remain under pressure. Remaining kit should be used within 30 days of opening.
Do not incinerate tanks. After tanks are empty, the hose should be removed and the tanks should be vented. Caution: Tanks will still be under pressure. Turn valves to the off position before removing the hoses. Protective glasses or goggles, nitrile gloves, clothing that protects from skin exposure and a certified respirator should be worn during this procedure. With tank inverted, slowly open tank valve, point away from face and allow pressure to completely vent. Caution: Empty tank could contain potential vapor toxicity hazard. Dispose cylinders in a well ventilated area.
Dispose of empty cylinders according to applicable federal, state and local regulations. Check with your local waste disposal service for guidance.
Have a well-insulated day and please call us if you have any questions at all.